H3c-technologies H3C SecPath F5020 Bedienungsanleitung PDF herunterladen (Seite 45)

Ste

Command

Remarks

3. Bind a physical

interface to the IRF

port.

port group interface

interface-type

interface-number [ mode

{ enhanced | normal } ]

By default, no physical interfaces are bound to

any IRF port.

Repeat this step to assign multiple physical

interfaces to the IRF port.

Each IRF port can have a maximum of eight

physical interfaces.

When you bind physical interfaces to an IRF

port, set all the physical interfaces to the same

mode: enhanced or normal.

If you do not specify a mode, the enhanced

mode applies.

Saving configuration to the next-startup

configuration file

Save the running configuration before converting to the IRF mode. The mode change requires a reboot,

which causes all unsaved settings to be lost.

Perform the following task in any view:

Task Command

Save the running configuration to

the next-startup configuration file.

save [ safely ] [ backup | main ] [ force ]

Connecting IRF physical interfaces

Connect the devices into a daisy chain.

When you connect two neighboring IRF members, connect the physical interfaces of IRF-port 1 on one

member to the physical interfaces of IRF-port 2 on the other (see Figure 15).

IMPORTANT:

• Do not connect physical interfaces of both IRF ports on one member device to the physical interfaces of

both IRF ports on the other.

• No intermediate devices are allowed between neighboring members.

Figure 15 Connecting IRF physical interfaces

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 81 82

Keine Kommentare

H3c-technologies H3C SecPath F5020 Bedienungsanleitung Seite 45