H3c-technologies H3C S12500 Series Switches Bedienungsanleitung PDF herunterladen

H3C SFP/SFP+/XFP Transceiver

Modules Installation Guide

(CH&EN,V1.08)

BOM: 3105A00Y

IMPORTANT:

• Carefully read this guide before installing a transceiver module.

• The descriptions in first four sections in this guide are applicable

to all SFP, SFP+, and XFP transceiver modules provided by H3C

and the descriptions in the last section are applicable to SFP+

transceiver modules and SFP+ DAC/AOC cables.

Support for transceiver modules depends on the device model. For more

information, see the installation guide.

Wearing an ESD wrist strap

Be sure to wear an ESD wrist strap when installing or removing a

transceiver module.

Make sure the wrist strap makes good skin contact and attach the wrist

strap wire to the ESD jack (if any) on the device chassis as shown in the

left part of Figure 1,

or to the rack with an alligator clip as shown in the

right part of Figure 1.

If y

ou also use ESD gloves, wear the wrist strap outside an ESD glove

and ensure that it has good contact with the glove.

1 2 3 4 5 6 7 8

Inhaltsverzeichnis

Seite 1 - (CH&EN,V1.08)

1 H3C SFP/SFP+/XFP Transceiver Modules Installation Guide (CH&EN,V1.08) BOM: 3105A00Y IMPORTANT: • Carefully read this guide before installing

Seite 2

2 Figure 1 Grounding the ESD wrist strap Installing a transceiver module CAUTION: • When installing or removing a transceiver module, avoid touch

Seite 3 - Verifying the installation

3 the socket (you can feel that the top and bottom spring tabs catch in the socket). See Figure 2. In case of limited space, you can gently push again

Seite 4

4 Transfer Distance(km) : 40(9um) Digital Diagnostic Monitoring : YES Vendor Name : H3C The output varies by transcei

Seite 5

5 Wrong installation and removal practices Figure 4 Installing/removing a transceiver module without wearing an ESD wrist strap Installing or removi

Seite 6

6 SFP+ transceiver module and SFP+ DAC/AOC cable installation guidelines Installing an SFP+ transceiver module Take an SFP+ transceiver module that yo

Seite 7

7 • For an SFP+ transceiver module that you will install with the clasp at the top, there should be space between the transceiver module bottom and t

Seite 8

8 To remove an SFP+ DAC/AOC cable, apply gentle pressure with your thumb to the connector, and then pull the clasp on the cable in a parallel directio